After Later Audio G&T 1U

After Later Audio G&T 1UTake your gates and generate triggers and take your triggers and generate a gate. Gate to Trigger section Takes a gate signal and gives a trigger output on both the rise and fall of that gate. The IN LED will illuminate while the gate input is high. Trigger to Gate section Takes a trig signal to start a gate signal and is normalized from the fall output in the Gate to Trig section. The gate length knob controls the gate length. The fall output will

This sorcerer’s box brings enormous sample processing ability to the table

The upper output is still active for channels 1-3 and this is useful for an effects buss

making your distorted sound easier to mix with the original one

oscillator 1 pulse width

but when using a trigger in ASR mode there will be almost no sustain as the duration of triggers is very short

The two Modulation Oscillators each have a single output and a waveform selector

In fully CCW position the signal appears only at the left output (OUT L)

Following the input section is a hold circuit

Trigger signals received at the Swing module’s clock input are sequentially routed to four outputs

The lower position gives emphasis on the low end

but using external clock to drive the onboard sequencer can result in unexpected phrases

attenuated by the foot pedal