Male to Male Dupont Jumper Wires 40 Pieces Cable

Male to Male Dupont Jumper Wires 40 Pieces CableMale to Male Jumper Cables These male to male jumper wires are popular choices for interconnecting female berg strip connector header pins in development boards, sensor modules, motor drivers, etc. They are flexible, easily detachable and are of good quality with end to end length of 21cm and compatible with 2. 54mm spacing pin headers. Best suitable with Arduino, Raspberry Pi, Sensor Modules, Beagle Bone, Single Board Computers, and other development

Check individual sensor voltage requirements before use

I/O Pins : 6 (2 are used for USB only if your program actively communicates over USB otherwise you can use all 6 even if you are programming via USB)

Net Weight: 6

NC1 - NC8: normally closed relay interface relay shorted with COM ago

Integrated 10bit ADC

by inclusion into Makefiles

Module type: 4 channel 433Mhz RF learning wireless receiver module

Measure Current Range: -20A ~ 20A

If you don’t require the pull-up resistors you can open the jumpers by cutting the trace connecting them

Adopts high quality of the RF-04 double-sided material

anti-conductivity

Total rotational angle : 300° ± 5°