Milling arbors for screw-in cutters BT 40 - M16 - 177 - LB150

Milling arbors for screw-in cutters BT 40 - M16 - 177 - LB150Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Delivery with test certificate All holders are made of forged steel

SK 30 without coolant exit bores on the end faceDelivery:

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

- According to DIN 69895 for HSK-A and HSK-E hollow taper shanks

clamping depth = 47

set and data button

All functional surfaces fine machined

For internal machining with boring bars

Easy to read dial face

Tensile strength in the core of min

With clamping screw and O-ring

On machining centres without synchronised spindles