ULN 2003 Break out Board for Stepper Motor

ULN 2003 Break out Board for Stepper MotorDESCRIPTION The Mini Stepper Motor Driver is small size and easy to use. It used ULN2003 to amplify the control signal from the Arduino. This Ultra Lightweight and cheap option commonly used to run and control the small applications stepper motors. The step motor is to a machine to convert pulse to angular displacement. So if you give stepper driver a certain pulse signal, it will drive step motor to a certain angle. you can control the angle the

Robo Chasis - Big

and smart sensing projects

This module has SPI interface which is compatible with any sd card and it use 5V or 3

Supply Voltage : 8

Load Capacity: 1 to 15 kg

Here we make use of Phototriac coupler to turn it ON and OFF

This powerful (200 nanosecond instruction execution) yet easy-to-program (only 35 single word instructions) CMOS Flash-based 8-bit microcontroller packs Microchip’s powerful PIC® MCU architecture into an 8-pin package and features 1 channel comparator and 128 bytes of EEPROM data memory

The photo diode is a bipolar type transistor with transparent casing so that the base of the transistor junction may receive photons

Photo resistor module

The ULN2803 is a Darlington array IC it can be used to drive Stepper and DC Motors

Dimensions:20mm

6 pin connector for EZ connect to MEGA BLACK