Shrink chuck 4,5° HSK 100 - 32 - 120

Shrink chuck 4,5° HSK 100 - 32 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

- Stainless steel 1

better chip evacuation

- Especially suitable fore wire EDM

All tool sizes can be combined

Spannkraft voreinstellbar durch Rillenmarkierung

For adaption from SK/ISO to PSC (ISO 7388-1 to ISO 26623-1)

Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

5-30mm and 25-50mm range are supplied with setting rings

Ring gauge accuracy according to DIN 2250Delivery:

05mm / 1/128"

Ground on the inside and outside

Instructions for use