Shrink chuck 4,5° BT 50 - 12 - 100

Shrink chuck 4,5° BT 50 - 12 - 100Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Ø 125 mm with locks

For safe clamping of taps in end mill holders according to DIN 1835 B

Standard (over 25mm range)

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

driving ring and feather key All holders are made of forged steel

automatically inversion of measuring direction

Plug gauge sizes according to DIN 2245

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance5

For mounting taps

Improves chip evacuation and decreases the risk for chip jamming

PSC to PSC adapter with axial clamping

Tensile strength in the core of min