ER-Collet chuck HSK 100 - 2/16 - 100 | ER 25

ER-Collet chuck HSK 100 - 2/16 - 100 | ER 25Application: For mounting straight shank tools in collets. Delivery: With balanced clamping nut All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

A possible increase of axial force during the tapping process is reduced to a minimum

The origin point is retained throughout the life of the battery

quick and simple measuring of the clamping force of hydraulic chucks

Clamping screw

Mirror polished surfaces

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

Ratchet Stop

- Automatic switch-on when the measuring surface is moved

5-30mm and 25-50mm range are supplied with setting rings

Plug gauge sizes according to DIN 2245

Calibration certificate

In the tailstock of the lathe so that no friction occurs between the workpiece and the tip