9/16" Cobalt Drill Bit with 3/8" Reduced Shank, D/ACO

9/16" Cobalt Drill Bit with 3/8" Reduced Shank, D/ACOProduct Description Cobalt drill bits are are effective in drilling tough, high tensile strength materials such as cast iron, inconel, stainless steel and titanium. They display high red hardness, permitting speeds up to 30% greater than with conventional M2 high speed steel. They have a 135 split point tip for fast penetration and accurate drilling. Compared to a conventional 118 degree tip, these drills wont go "walking" on you. Reduced Shank Drills

stout long nose pliers with crosscut teeth have thick jaws that taper to a fine tip just at the nose to prevent twisting • Slip joint pliers use universal three-zone jaws to grip a wide variety of shapes and a shear-type wire cutter to snip soft and hard wire • Groove joint pliers use sharp

Part Number DEWCBR1-5/8

Part Number ANC5-530-281

Thumb Saddle Reinforced with DuPont™ Kevlar®

This set includes slotted drivers with modular driver organizers

drive (20 - 200 in-lb)

Alloy Flat Socket Head Cap Screws

5 HRC for use on impact wrenches • Corrosion-Resistant – The socket is coated with a manganese phosphate finish to resist corrosion • Two Size Markings – The size is marked with a high-visibility laser marking and a permanent stamped marking that won't rub off • Friction Ring or Detent Pin Anvils – Smooth walls inside the drive end and a detent pin hole make the bit sockets compatible with both drive tool anvil types

Sound and vibrations can be turned off

The set includes 1/2 inch drive bit sockets in an open top drawer and a stacking drawer rack

Part Number: BIT-T/A54890

Part Number: BIT-T/A54235