Shrink chuck 4,5° HSK 63 - 14 - 120

Shrink chuck 4,5° HSK 63 - 14 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Upon switching on the display will read the actual absolute measuring position

Positive clamping due to penetration of the hardened claw tips

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

Suitable for tool arbor with polygonal shank (PSC) - ISO 26623-1

5-30mm and 25-50mm range are supplied with setting rings

lockable in different positions

Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

With balanced clamping nut All holders are made of forged steel

Improves chip evacuation and decreases the risk for chip jamming

Adaptive interface machine direction (ADINTMS): BMT driven turret interface -size BT65A

DIN 1835 form A+B+E and DIN 6535 form HB+HE

3 µm radial run-out with a 2 µm clamping nut